Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Isuzu OasisFACTORY OEM SERVICE PROCEDURE
Gear Position Switch Test
- Disconnect gear position switch connector, located above transaxle, near gear position switch. See Fig 1 .
- Using a DVOM, check continuity between specified terminals of gear position switch. See GEAR POSITION SWITCH CONTINUITYΒ table. Replace gear position switch if continuity is not as specified.
GEAR POSITION SWITCH CONTINUITY
| Shift Lever Position | Continuity Between Terminals No. |
|---|---|
| Park | 1, 3 & 10 |
| Neutral | 1, 3 & 8 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
