1999 Isuzu OasisFACTORY OEM SERVICE PROCEDURE

Generator Control System Test

NOTE: Ensure Electrical Load Detector (ELD) system related DTC(s) do not exist. Diagnose DTC(s) first, if present. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
  1. Turn ignition off. Disconnect 4-pin generator harness connector. Start engine and turn on headlights (high beam). Check voltage between generator harness connector terminal No. 2 (White/Green wire) and battery positive terminal. If voltage reading is one volt or less, go to next step. If voltage reading is not one volt or less, go to step Β 3 .
  2. Turn ignition and headlights off. Disconnect ECM 31-pin harness connector. Check continuity of White/Green wire between ECM harness connector terminal No. 2 and generator harness connector terminal No. 2. See WIRING DIAGRAMSΒ  . If continuity exists, perform GENERATOR/REGULATOR TESTΒ  . If continuity does not exist, repair open in White/Green wire between generator and ECM.
  3. Turn ignition and headlights off. Disconnect ECM 31-pin connector. Check continuity between ECM harness connector terminal No. 2 (White/Green wire) and ground. If continuity does not exist, replace ECM with a known-good unit and repeat step Β 1 . If continuity exists, repair short in White/Green wire between generator and ECM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.