1998 Isuzu Trooper LSFACTORY OEM SERVICE PROCEDURE

Service Intervals & Specifications

REPLACEMENT INTERVALS (1)

Component Miles
Air Filter
Normal Service 30,000
Severe Service (2) 15,000
Coolant 30,000
Engine Oil & Filter
Normal Service 3000
Fuel Filter
Except Hombre 30,000
Hombre 50,000
PCV Valve (4) 100,000
Spark Plugs 100,000
Spark Plug Wires 60,000
Automatic Transmission Fluid
Normal Service (3)
Severe Service (Except Hombre) 20,000
Severe Service (Hombre) 50,000
Manual Transmission Fluid (5)
Transfer Case Fluid (4WD) (5)
Front Differential Fluid (4WD) (5)
Rear Differential Fluid (5)
Repack Front Wheel Bearings (2WD) 15,000
Inspect Valve Clearance
Amigo, Rodeo & Passport 15,000
Replace Timing Belt (6) 75,000
Replace Power Steering Fluid 30,000
Rotate Tires & Check Brakes
Except Trooper & SLX 6000
Trooper & SLX 7500
(1) Different interval is required for normal and severe service. Severe service is described as trailer towing, off-highway operation, snow removal operation, or operating in dusty or excessively hot conditions.
(2) Inspect air filter every 15,000 miles and replace as necessary. Replace at 30,000 miles unless previously replaced during inspection.
(3) There is no need to change fluid unless used under severe conditions.
(4) Inspect at scheduled interval and replace as necessary.
(5) Replace fluid at 15,000 miles. After first fluid change, replace fluid every 30,000 miles thereafter.
(6) Inspect water pump (where applicable).
VALVE CLEARANCE ADJUSTMENT INTERVALS

Application Miles
Amigo, Rodeo & Passport
2.2L (1)
3.2L 60,000
Hombre (1)
Trooper & SLX 60,000
(1) Hydraulic lash adjusters are used. No adjustment is required.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.