1998 Isuzu Oasis SFACTORY OEM SERVICE PROCEDURE

Master Switch Test

Remove power window master switch. See MASTER POWER WINDOW SWITCH  under REMOVAL & INSTALLATION. Using an ohmmeter, check resistance of switch terminals with switch in indicated positions. If continuity is not as specified, replace switch. See Figure -Figure . See appropriate POWER WINDOW MASTER SWITCH TEST table.

POWER WINDOW MASTER SWITCH TEST (CIVIC COUPE & HATCHBACK) (1)

Switch Position Main Switch Pin Continuity
Driver's Switch N/A (2)
Passenger's Switch
Off On A2, A5 & A7
Off Off A2 & A7
Up On A2 & A5; A6 & A7
Up Off A6 & A7
Down On A2 & A6; A5 & A7
Down Off A2 & A6
(1) For terminal identification, see Figure .
(2) See SWITCH INPUT TEST. See Figure .
POWER WINDOW MASTER SWITCH TEST (CIVIC SEDAN) (1)

Switch Position Main Switch Pin Continuity
Left Front Switch N/A (2)
Right Front Switch
Off On B1, B11 & C1
Off Off B1 & B11
Up On B1 & B2; B11 & C1
Up Off B1 & B2
Down On B1 & C1; B2 & B11
Down Off B2 & B11
Right Rear Switch
Off On B9, B10 & C1
Off Off B9 & B10
Up On B8 & B9; B10 & C1
Up Off B8 & B9
Down On B8 & B10; B9 & C1
Down Off B8 & B10
Left Rear Switch
Off On B14, B16 & C1
Off Off B14 & B16
Up On B14 & B15; B16 & C1
Up Off B14 & B15
Down On B14 & C1; B15 & B16
Down Off B15 & B16
(1) For terminal identification, seeFigure .
(2) See SWITCH INPUT TEST. See Figure .
POWER WINDOW MASTER SWITCH TEST (CR-V) (1)

Switch Position Main Switch Pin Continuity
Left Front Switch N/A (2)
Right Front Switch
Off On A1, A2 & B1
Off Off A1 & A2
Up On A1 & A9
Up Off A1 & A9
Down On A2 & A9
Down Off A2 & A9
Right Rear Switch
Off On A13, A14 & B1
Off Off A13 & A14
Up On A6 & A14
Up Off A6 & A14
Down On A6 & A13
Down Off A6 & A13
Left Rear Switch
Off On A7, A8 & B1
Off Off A7 & A8
Up On A8 & A12
Up Off A8 & A12
Down On A7 & A12
Down Off A7 & A12
(1) For terminal identification, see Figure .
(2) See SWITCH INPUT TEST. See Figure .
POWER WINDOW MASTER SWITCH TEST (ODYSSEY & OASIS) (1)

Switch Position Main Switch Pin Continuity
Left Front Switch N/A (2)
Right Front Switch
Off On A10, A12 & B2
Off Off A10 & A12
Up On A1 & A12; A10 & B2
Up Off A1 & A12
Down On A1 & A10; A12 & B2
Down Off A1 & A10
Right Rear Switch
Off On A9, A11 & B2
Off Off A9 & A11
Up On A2 & A11; A9 & B2
Up Off A2 & A11
Down On A2 & A9; A11 & B2
Down Off A2 & A9
Left Rear Switch
Off On A13, A15 & B2
Off Off A13 & A15
Up On A6 & A15; A13 & B2
Up Off A6 & A15
Down On A6 & A13; A15 & B2
Down Off A6 & A13
(1) For terminal identification, see Figure .
(2) See SWITCH INPUT TEST. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.