1998 Isuzu Oasis LSFACTORY OEM SERVICE PROCEDURE

Fast Idle Speed

FAST IDLE SPEED SPECIFICATIONS (1)

Application RPM
Accord
2.3L 1350-1450
3.0L (2)
Civic (2)
CR-V 1300-1700
Oasis & Odyssey 1100-1500
Prelude 1200-1600
(1) Transmission in Neutral or Park.
(2) Information not available from manufacturer.
IGNITION TIMING (Degrees BTDC - RED MARK @ RPM) (1)

Application Specification
Accord
2.3L 10-14 @ 650-750
3.0L 8-12 @ 630-730
Civic
A/T Or CVT (2)(3) 10-14 @ 650-750
M/T (2)(3) 10-14 @ 620-720
CR-V 14-18 @ 700-800
Oasis & Odyssey 10-14 @ 650-750
Prelude 13-17 @ 650-750
(1) Check in no load condition (headlights, blower motor, rear defogger, A/C and cooling fan off) with M/T in neutral or A/T in Neutral or Park position.
(2) Canadian 10-14 @ 700-800.
(3) With SCS service connector (T/N 07PAZ-0010100 ) connected to 2-pin service check connector located under passenger side instrument panel.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.