1998 Isuzu Oasis LSFACTORY OEM SERVICE PROCEDURE

Ignition Timing

NOTE: Always refer to SERVICE INFORMATION underhood label in engine compartment. If underhood label and article specifications differ, always use underhood label specifications.
IGNITION TIMING (Degrees BTDC - RED MARK @ RPM) (1)

Application Specification
Accord
2.3L 10-14 @ 650-750
3.0L 8-12 @ 630-730
Civic
A/T Or CVT (2)(3) 10-14 @ 650-750
M/T (2)(3) 10-14 @ 620-720
CR-V 14-18 @ 700-800
Oasis & Odyssey 10-14 @ 650-750
Prelude 13-17 @ 650-750
(1) Check in no-load condition (headlights, blower motor, rear defogger, A/C and cooling fan off) with M/T in neutral or A/T in Neutral or Park.
(2) Canadian 10-14 @ 700-800.
(3) With SCS service connector (T/N 07PAZ-0010100) connected to 2-pin service check connector located under passenger side instrument panel.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.