Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Isuzu Oasis LSFACTORY OEM SERVICE PROCEDURE
Ignition Switch Test
NOTE:
For Civic ignition switch test, see STARTERS - HITACHI DIRECT DRIVE article.
- Remove lower instrument panel cover and driver-side knee bolster. On Accord, Odyssey and Oasis, disconnect 7-pin connector from steering column harness. On CR-V and Prelude, disconnect 6-pin and 3-pin connector from steering column harness. See Fig 1 or Fig 2 .
- On all models, using DVOM, check continuity between specified connector terminals, with ignition switch in appropriate position. If continuity is not as specified, replace ignition switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.