Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Isuzu Trooper LSFACTORY OEM SERVICE PROCEDURE
Clearing Codes
- After repairs are performed, clear PCM memory of all stored codes. Ensure ignition is off. To clear codes, use diagnostic scan tool "clear DTCs" or "clear info" function. Follow instructions supplied by tool manufacturer, when clearing DTCs.
- DTCs can also be cleared by disconnecting any PCM power source or negative battery cable for at least 30 seconds. However, if disconnecting battery remember that other memory functions (clock, radio, etc.) will need to be reset.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.