Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Isuzu Rodeo LS, 2.6 EFACTORY OEM SERVICE PROCEDURE
Power Transistor
- Ensure ignition is off. Remove coil wire from distributor cap. Attach Spark Tester (J-26792), or, using insulated pliers, hold distributor terminal end of coil wire about 1/4" (5 mm) from metal surface.
- Disconnect and remove power transistor from under intake manifold. This involves removing right front wheel and rubber inner fender panel cover to access power transistor.
- Connect jumper wire between harness connector and power transistor connector Blue wire terminal. Connect negative end of 1.5-volt "D" battery to power transistor Green wire terminal. See Fig 1 . Connect positive end of 1.5-volt "D" battery to harness connect or Yellow wire terminal. Ground power transistor.
- Turn ignition on with engine off. Disconnect and connect jumper lead at power transistor connector several times. Verify spark is jumping across air gap at spark tester. If spark does not occur, check wiring for continuity or shorts. If wiring is okay, replace power transistor.
NOTE:
A faulty power transistor or circuit will set DTC(s). See appropriate TESTS W/CODES - 2.6L 4-CYL
article. Wire colors may vary. See appropriate wiring diagram in WIRING DIAGRAMSΒ
section.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
