Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU1996OASIS SREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - TESTS W/CODES
1996 Isuzu Oasis S
Engine Controls - Tests W/Codes
1996 Isuzu Oasis SSECTION Engine Controls - Tests W/Codes
- Introduction
- Self-Diagnostic System
- Test Equipment
- Connector Identification
- Circuit Tests
- Notes
- No DTC - Powertrain Control Module (Pcm)
- DTC P0106 - Manifold Absolute Pressure (Map) Sensor
- DTC P0107 - Map Sensor
- DTC P0108 - Map Sensor
- DTC P0112 - Intake Air Temperature (IAT) Sensor
- DTC P0113 - Intake Air Temperature (IAT) Sensor
- DTC P0116 - ECT Sensor
- DTC P0117 - Engine Coolant Temperature (ECT) Sensor
- DTC P0118 - Engine Coolant Temperature (ECT) Sensor
- DTC P0122 - Throttle Position (TP) Sensor
- DTC P0123 - Throttle Position (TP) Sensor
- DTC P0131 - Front Ho2S Sensor 1
- DTC P0132 - Front Ho2S Sensor 1
- DTC P0133 - Front Ho2S Sensor 1
- DTCS P0135 & P0141 - Ho2S Heater
- DTC P0137 - Rear Heated Oxygen Sensor (Ho2S) Sensor 2
- DTC P0139 - Rear Heated Oxygen Sensor (Ho2S) Sensor 2
- DTCS P0171 & P0172 - Fuel Supply System
- DTCS P0301, P0302, P0303, P0304, P0305 & P0306 - Misfire In One Cylinder
- DTCS P0301 Or P1300, P0302, P0303, P0304, P0305 & P0306 - Misfire Of Multiple Cylinders
- DTC P0325 - Knock Sensor (KS)
- DTCS P0335, P0336, P1361 & P1362 - Crankshaft Position/Top Dead Center (CKP/TDC) Sensor
- DTC P0401 - Exhaust Gas RECIRCULATION (EGR) System
- DTC P0420 - Three-Way Catalytic Converter (TWC)
- DTC P0441 - Evaporative Emission (EVAP) Control
- DTCS P0500 & P0501 - Vehicle Speed Sensor (VSS)
- DTC P0505 - Idle Control System
- DTCS P1107 & P1108 - Barometric Pressure (BARO) Sensor
- DTC P1297 - Electrical Load Detector (Eld)
- DTC P1298 - Electrical Load Detector (Eld)
- DTC P1359 - Crankshaft Position/Top Dead Center (CKP/TDC) Sensor
- DTCS P1381 & P1382 - Cylinder Position - (CYP) Sensor
- DTC P1459 - EVAP Control
- DTC P1491 - EGR System
- DTC P1498 - Exhaust Gas RECIRCULATION (EGR) System
- DTC P1508 - Idle Air Control (IAC) Valve
- DTC P1607 - Pcm Internal Circuit
- Summary
- Wiring Diagrams
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.