1995 Isuzu Trooper LS, AutomaticFACTORY OEM SERVICE PROCEDURE

Left Front

  1. Turn ignition off. Remove left front power window switch from door trim panel. Disconnect power window switch harness connectors. Turn ignition on. Using a voltmeter, check voltage between harness connector "A", terminal No. 7 (Blue/Black wire) and ground, then terminal No. 10 (Light Green/White wire) and ground. SeeFig 1 . Battery voltage should be present at each terminal.
  2. Turn ignition off. Using an ohmmeter, check for continuity between harness connector "A", terminal No. 1 (Black wire) and ground. Continuity should be present. Check for continuity between harness connector "A", terminals No. 5 (Blue/White wire) and No. 6 (Blue wire). Continuity should be present.
  3. Check for continuity between harness connector "B", terminal No. 5 (Red/Yellow wire) and ground. SeeFigure . Continuity should be present.
Fig 1: Front Power Window Switch Harness Connector Terminals (Connector "A")
G96E07616Courtesy of ISUZU MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.