1995 Isuzu Rodeo LS, RWDFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS

Component Component Location
A/T Shift Indicator Controller Behind dash, left of steering column.
Cruise Control Unit At right kick panel.
Electronic Brake Control Module (EBCM) (1995) Below right front seat.
Electronic Brake Control Module (EBCM) (1996) Right rear corner of engine compartment.
Electronic Ignition (EI) Assembly (3.2L) (1995) Center front of engine. See Figure .
Engine Control Module (ECM) (2.6L) (1995) Below center of dash. See Figure .
Engine Control Module (ECM) (3.2L) (1995) Below center of dash. See Figure .
Ignition Control Module (ICM) (3.2L) (1996) Top rear of engine. See Figure .
Powertrain Control Module (PCM) (1996) Below center of dash.
Sensing & Diagnostic Module (SDM) Below center of dash.
Shift Lock Controller Below shift lever cover.
Transmission Control Module (TCM) (1995) Behind dash, left of steering column.
Wheel Anti-Lock Brake Controller (Rear) (1996) Below right front seat.
Wiper Controller (Rear) Left side of luggage room, behind lower trim panel.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.