Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Isuzu Rodeo LS, 4WD, StandardFACTORY OEM SERVICE PROCEDURE
Ignition Coil
- Ensure ignition is off. Disconnect ignition coil wiring. Measure primary resistance between terminals "C" and "E". See Fig 1 . Measure secondary resistance between terminals "C" and "D". Measure insulation resistance between terminals "C" and body ground.
- Make sure resistance is within specification. Refer to the IGNITION COIL RESISTANCE (NON-HEI SYSTEMS) table. Replace coil if resistance is not within specification.
IGNITION COIL RESISTANCE (NON-HEI SYSTEMS)
| Application/Model (1) | Primary Ohms @ 68°F (20°C) | Secondary Ohms @ 68°F (20°C) | ||
|---|---|---|---|---|
| Rodeo 2.6L | .81-.99 | 7500-11,300 | ||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
