Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 32 - Exhaust Gas RECIRCULATION (EGR) Circuit: Notes
ECM controls a solenoid that regulates vacuum to the EGR valve. EGR control solenoid is cycled by ECM grounding White/Green wire. ECM calculates EGR control solenoid duty cycle using information from CTS and TPS. EGR control solenoid is energized when diagnostic terminal is grounded.
- With engine at normal operating temperature, Code 32 will set if the difference of EGR gas temperature between EGR on and EGR off is less than 45°F (7°C) or if signal voltage indicates an EGR gas temperature greater than 662°F (350°C) or less than -33°F (-36°C).
- Determines if problem is with EGR valve, EGR gas temperature sensor, ECM or wiring.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
