Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Isuzu Stylus AutomaticFACTORY OEM SERVICE PROCEDURE
Power Window Switch Continuity (Driver's Side Switch)
- Remove switch from door trim panel. Disconnect power window switch harness connector. Using an ohmmeter, check continuity between specified switch terminals with power window switch in specified position. See DRIVER'S POWER WINDOW SWITCH CONTINUITY CHARTΒ .
- For switch terminal identification, seeFigure . If continuity is not as specified, replace appropriate switch.
DRIVER'S POWER WINDOW SWITCH CONTINUITY CHART
| Switch & Position | Check Continuity Between Terminals: | |
|---|---|---|
| Left Front | ||
| DOWN | 1 & 10; 2 & 9 | |
| OFF | 1 & 10; 2 & 10 | |
| UP | 1 & 9; 2 & 10 | |
| Right Front | ||
| DOWN | 7 & 10; 9 & 12 | |
| OFF | 7 & 10; 10 & 12 | |
| UP | 7 & 9; 10 & 12 | |
| Left Rear | ||
| DOWN | 8 & 10; 9 & 11 | |
| OFF | 8 & 10; 10 & 11 | |
| UP | 8 & 9; 10 & 11 | |
| Right Rear | ||
| DOWN | 3 & 10; 4 & 9 | |
| OFF | 3 & 10; 4 & 10 | |
| UP | 3 & 9; 4 & 10 | |
| Lock | ||
| OFF (Unlock) | 6 & 9 | |
| ON (Lock) | N/A | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
