1992 Isuzu Trooper LS, AutomaticFACTORY OEM SERVICE PROCEDURE

Power Window Switch Continuity (Driver's Side Switch)

  1. Remove switch from door trim panel. Disconnect power window switch harness connector. Using an ohmmeter, check continuity between specified switch terminals with power window switch in specified position. See DRIVER'S POWER WINDOW SWITCH CONTINUITY CHARTΒ  .
  2. For switch terminal identification, seeFigure . If continuity is not as specified, replace appropriate switch.
DRIVER'S POWER WINDOW SWITCH CONTINUITY CHART

Switch & Position Check Continuity Between Terminals:
Left Front
DOWN 1 & 12; 2 & 7
OFF 1 & 12; 2 & 12
UP 1 & 7; 2 & 12
Right Front
DOWN 7 & 13; 12 & 14
OFF 12 & 13; 12 & 14
UP 7 & 14; 12 & 13
Left Rear
DOWN 6 & 12; 7 & 9
OFF 6 & 12; 9 & 12
UP 6 & 7; 9 & 12
Right Rear
DOWN 5 & 7; 10 & 12
OFF 5 & 12; 10 & 12
UP 5 & 12; 7 & 10
Lock
OFF (Unlock) (1) *
ON (Lock) (2) *
(1) Terminals 5, 6, 9, 10, 12, 13 and 14 should have continuity when ohmmeter is connected between any 2 terminals.
(2) Terminals 5, 6, 9, 10, 13 and 14 should have continuity when ohmmeter is connected between any 2 terminals.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.