Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Isuzu Impulse AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||||||
|---|---|---|---|---|---|---|---|
| Ball Joint Nut | 48 (65) | ||||||
| Center Support-To-Body Bolt | 37 (50) | ||||||
| Crossmember-To-Body Bolt | 137 (186) | ||||||
| Engine Brace | 28 (38) | ||||||
| Flywheel-To-Crankshaft Bolt (1) | (2) 21 (29) | ||||||
| Hub Nut | (3) 137 (186) | ||||||
| Mount-To-Frame Bolt | 51 (69) | ||||||
| Mount-To-Transaxle Bolt | 38 (51) | ||||||
| Pressure Plate-To-Flywheel Bolt | 14 (19) | ||||||
| Drive Shaft Bolt | 26 (35) | ||||||
| Rear Mount Bolt | 76 (103) | ||||||
| Steering Shaft Bolt | 30 (40) | ||||||
| Tie Rod End Nut | 29 (39) | ||||||
| Torque Rod-To-Bracket Bolt | 28 (38) | ||||||
| Torque Rod-To-Transaxle Bolt | 38 (51) | ||||||
| Transaxle-To-Engine Bolt | 69 (94) | ||||||
|
|||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
