Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 23B: Mat Sensor CKT (Hi Temp Indicated): Notes
The MAT sensor uses a thermistor to control signal voltage to the ECM. The ECM applies 4-6 volts on circuit No. 472 to MAT sensor. When manifold air is cold, sensor resistance is high and ECM will see a high voltage. As air temperature increases, sensor resistance decreases and the voltage drops.
- This determines if Code 23B is the result of a hard failure or an intermittent condition. Code 23B will set if MAT temperature is greater than 334Β°F (135Β°C) for more than 2 seconds.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
