Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electronic Spark Control (ESC), (Trooper 2.8L)
To test ESC system, proceed to CHART C-5: ESC SYSTEM (TROOPER 2.8L). See Fig 1 . The ESC module is located on right side fenderwell and contains a 4-pin connector.
Electronic Spark control is accomplished using an ESC control module that sends a voltage signal to the ECM. As knock sensor detects engine knock, voltage from ESC module to ECM is shut off, signaling ECM to retard timing (if engine speed is greater than 900 RPM).
- If code 43 is not set, but a knock signal is indicated while running at 1500 RPM, listen for an internal engine noise. Under a no load condition, there should not be any detonation. If knock is indicated, an internal engine problem may exist.
- Usually a knock signal can be generated by tapping on the right exhaust manifold. This test can also be performed at idle. Test No. 1 was run at 1500 RPM to determine if a constant knock signal was present, which would affect engine performance.
- This will test whether the knock signal is caused by the sensor, a basic engine problem or the ESC module.
- If the module ground circuit is faulty, the ESC module will not function correctly. The test light should light, indicating the ground circuit is okay.
- Using a test light from 12 volts at circuit No. 496 should generate a knock signal to determine whether the knock sensor is at fault or the ESC module can't recognize a knock signal.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
