1990 Isuzu Impulse AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
Blower Motor Resistor Under right side of dash, on A/C-heater housing.
Brake Diodes Under carpet, under driver's seat.
Diagnostic Connectors
Automatic Transmission Behind right front kick panel.
Diagnostic Energy Reserve Module Behind right front kick panel.
Engine Control (ALDL) Behind right front kick panel. See Figure .
Dropping Resistor Near brake fluid reservoir.
Injectors On rear side of engine. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.