Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Isuzu I-Mark LSFACTORY OEM SERVICE PROCEDURE
Fuel Pump Performance Test (I-Mark)
- Disconnect negative battery cable. Remove fuel inlet hose from carburetor. See Figure . Connect a pressure gauge between inlet hose and carburetor with a "T" fitting.
- Reconnect negative battery cable. Start engine and run at idle. Note pressure gauge reading. Compare with specifications in the FUEL PUMP SPECIFICATIONSΒ table below.
- Stop engine. Disconnect negative battery cable. Remove pressure gauge and "T" fitting. Reconnect negative battery cable. Place fuel inlet line in graduated cylinder. Crank engine for 30 seconds.
- Compare results with FUEL PUMP SPECIFICATIONSΒ below. If not within specification, replace fuel pump. Reconnect fuel inlet line.
FUEL PUMP SPECIFICATIONS
| Test | Result | |
|---|---|---|
| Amigo & Pickup (Pressure) | 3.56 psi (0.25 kg/cm2 ) | |
| I-Mark | ||
| Pressure | 3.8-4.7 psi (0.27-0.33 kg/cm2 ) | |
| Delivery (30 Seconds) | 0.428 quart (0.4 liter) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
