Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Isuzu Trooper II Base, AutomaticFACTORY OEM SERVICE PROCEDURE
TCU Code 6 - Throttle Position Sensor Signal
- Pull water shield cover back from TPS connector. Do not disconnect. With ignition on, check voltage between REd wire and Black wire. Voltage should be 4.5-5.5 volts
- Switch positive lead of voltmeter to White wire. With throttle at idle, reading should be higher than 4 volts. At wide open throttle the reading should be less than 2 volts. Difference of readings between idle and wide open throttle should be 2.6-4.6 volts.
- TPS is adjustable. If adjustment will not bring correct voltage readings, replace TPS.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.