Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1984 Isuzu Impulse AutomaticFACTORY OEM SERVICE PROCEDURE
Knock Sensor
- Unplug leads of knock sensor at connector. Measure resistance between terminals with ohmmeter. Normal resistance should be 650-800 ohms. Measure continuity of wiring harness. Continuity (0 ohms) should be found between connector end of Black wire and terminal No. 28 of ECU plug.
- Continuity should exist between connector end of White wire and terminal No. 37 of ECU plug. Make sure that there is no continuity (open circuit) between terminal No. 37 of ECU plug and ground. If ignition timing is correct and engine produces heavy knocking, replace knock sensor. If knock continues, replace ECU.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
