Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1983 Isuzu Impulse AutomaticFACTORY OEM SERVICE PROCEDURE
Repair and Diagnosis: Electrical: Starter: Description
Starter is a conventional 12-volt, 4-pole brush-type motor, with either direct or reduction gear drive. The starter-mounted solenoid shifts overrunning clutch and pinion into flywheel when starter is energized.
HITACHI STARTER APPLICATION
| Model | (1) Type or Part No. | |||
|---|---|---|---|---|
| I-Mark | ||||
| Gasoline | 8-94222-688-0 | |||
| Diesel | 8-94115-567-0 | |||
| Impulse | 8-94130-560-0 | |||
| P'UP | ||||
| Gasoline | 8-94234-065-0 | |||
| Diesel | 5-81100-183-0 | |||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.