1983 Isuzu Impulse AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Relays

RELAYS LOCATION

Component Location
A/C-Heater Blower Motor Relay In right side switch module.
Blower Motor Relay (2) Mounted on left side of blower motor box.
A/C Relay On evaporator upper case. See Figure .
Charge Warning Relay In relay block on right inner fender panel. See Figure .
Dimmer Relay In fuse/relay block in front to battery. See Figure & Figure .
Fuel Pump Relay In relay block on right inner fender panel.
Headlight Cover Relay In fuse/relay block in front of battery. See Figure & Figure .
Horn Relay On right inner fender panel. See Figure .
Lighting Relay In fuse/relay block in front of battery. See Figure & Figure .
Main Relay In relay block on right inner fender panel.
Overdrive Relay Under left side of dash.
Seat Belt Relay Behind instrument cluster.
Starter Relay In fuse/relay block in front of battery. See Figure & Figure .
Tail Light Relay In fuse/relay block in front of battery. See Figure & Figure .
Wiper Relays (2) On right inner fender panel. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.