Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Exhaust Camshaft Position Sensor
FUNCTIONS WITHIN THE SYSTEMÂ
The ECM identifies the cylinders from the combination of the exhaust camshaft position sensor signal and the crankshaft position sensor signal input into it.
INDIVIDUAL FUNCTION WITHIN THE SYSTEMÂ
The ECM inputs the voltage change caused by the change in magnetic field generated close to the exhaust camshaft position sensor, and the timing of the change, as signal voltage.
INDIVIDUAL OPERATIONÂ
The exhaust camshaft position sensor consists of a permanent magnet and MRE IC. When engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. Due to the changing magnetic field, the voltage from the sensor changes.
COMPONENT LOCATIONÂ
The exhaust camshaft position sensor is installed on the exhaust camshaft right side (engine rear side) of the camshaft bracket.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
