Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2024 Infiniti QX55 EssentialFACTORY OEM SERVICE PROCEDURE

Removal and Installation

REMOVAL

Using a suitable tool release clips and remove rear center console finisher. Refer to Exploded View .
Using a suitable tool release clips and remove center console finisher (LH). Refer to Exploded View .
Using a suitable tool release clips and pawls and remove the shift selector finisher. Refer to Exploded View .
Disconnect the harness connector from push button ignition switch.
Disconnect the harness connector from electric parking brake switch.
Disconnect the harness connector from drive mode switch.
Remove screws (A) and remove drive mode switch (1) from shift selector finisher.

Courtesy of NISSAN NORTH AMERICA, INC.
Using a suitable tool release pawls and remove the drive mode switch (1) from the drive mode switch carrier (2).

Courtesy of NISSAN NORTH AMERICA, INC.

: Pawl

INSTALLATION

Installation is in the reverse order of removal.

Chapter Navigation

Return to Chapter: Drive Mode Switch

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.