2024 Infiniti QX55 EssentialFACTORY OEM SERVICE PROCEDURE

Work Procedure

  1. SAVING VEHICLE SPECIFICATION (BCM) 
    1. SYMBOL CONSULT Perform "Before Replace ECU" of "Read / Write Configuration" to save or print current vehicle specification. Refer to Work Procedure .
      NOTE: SYMBOL If "Before Replace ECU" of "Read / Write Configuration" cannot be used, use the "Manual Configuration" after replacing BCM.

    >>

    GO TO 2.

  2. SAVING VEHICLE SPECIFICATION (CAN GATEWAY) 
    1. SYMBOL CONSULT Perform "Before Replace ECU" of "Read / Write Configuration" to save or print current vehicle specification. Refer to Work Procedure .
      NOTE: SYMBOL If "Before Replace ECU" of "Read / Write Configuration" cannot be used, use the "Manual Configuration" after replacing BCM.

    >>

    GO TO 3.

  3. SAVING VEHICLE SPECIFICATION (TPMS) 
    1. SYMBOL CONSULT Perform "Before Replace ECU" of "Read / Write Configuration" to save or print current vehicle specification. Refer to Work Procedure (Before Replacement) .
      NOTE: SYMBOL If "Before Replace ECU" of "Read / Write Configuration" cannot be used, use the "Manual Configuration" after replacing BCM.

    >>

    GO TO 4.

  4. REPLACE BCM 
    1. Replace BCM. Refer to Removal and Installation .

    >>

    GO TO 5.

  5. WRITING VEHICLE SPECIFICATION (BCM) 
    1. SYMBOL CONSULT Perform "After Replace ECU" of "Read / Write Configuration" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure .

    >>

    GO TO 6.

  6. REGISTER INTELLIGENT KEYS 
    1. SYMBOL CONSULT For initialization and registration of Intelligent Keys, refer to CONSULT Immobilizer mode and follow the on-screen instructions.
      NOTE: SYMBOL If the customer has Virtual I-Key application, reprogram and register it as a third keyfob, and follow the same configuration as vehicle Intelligent Key.

    >>

    GO TO 7.

  7. WRITING VEHICLE SPECIFICATION (TPMS) 
    1. SYMBOL CONSULT Perform "After Replace ECU" of "Read / Write Configuration" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure (After Replacement) .

    >>

    GO TO 8.

  8. WRITING VEHICLE SPECIFICATION (CAN GATEWAY) 
    1. SYMBOL CONSULT Perform "After Replace ECU" of "Read / Write Configuration" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure .

    >>

    GO TO 9.

  9. INITIALIZE TPMS 
    1. Perform TPMS initialization. Refer to Work Procedure .

    >>

    Work End.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.