Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Infiniti QX55 EssentialFACTORY OEM SERVICE PROCEDURE
Work Procedure
- SAVING VEHICLE SPECIFICATION (BCM)
CONSULT Perform "Before Replace ECU" of "Read / Write Configuration" to save or print current vehicle specification. Refer to Work Procedure .
NOTE:If "Before Replace ECU" of "Read / Write Configuration" cannot be used, use the "Manual Configuration" after replacing BCM.
>>
GO TO 2.
- SAVING VEHICLE SPECIFICATION (CAN GATEWAY)
CONSULT Perform "Before Replace ECU" of "Read / Write Configuration" to save or print current vehicle specification. Refer to Work Procedure .
NOTE:If "Before Replace ECU" of "Read / Write Configuration" cannot be used, use the "Manual Configuration" after replacing BCM.
>>
GO TO 3.
- SAVING VEHICLE SPECIFICATION (TPMS)
CONSULT Perform "Before Replace ECU" of "Read / Write Configuration" to save or print current vehicle specification. Refer to Work Procedure (Before Replacement) 3CH CAN GATEWAY or Work Procedure (Before Replacement) 6CH CAN GATEWAY.
NOTE:If "Before Replace ECU" of "Read / Write Configuration" cannot be used, use the "Manual Configuration" after replacing BCM.
>>
GO TO 4.
- REPLACE BCM
- Replace BCM. Refer to Removal and Installation .
>>
GO TO 5.
- WRITING VEHICLE SPECIFICATION (BCM)
CONSULT Perform "After Replace ECU" of "Read / Write Configuration" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure .
>>
GO TO 6.
- REGISTER INTELLIGENT KEYS
- For initialization and registration of Intelligent Keys, refer to CONSULT Immobilizer mode and follow the on-screen instructions.
>>
GO TO 7.
- WRITING VEHICLE SPECIFICATION (TPMS)
CONSULT Perform "After Replace ECU" of "Read / Write Configuration" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure (After Replacement) .
>>
GO TO 8.
- WRITING VEHICLE SPECIFICATION (CAN GATEWAY)
CONSULT Perform "After Replace ECU" of "Read / Write Configuration" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure .
>>
GO TO 9.
- INITIALIZE TPMS
- Perform TPMS initialization. Refer to Work Procedure .
>>
Work End.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
