Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Work Flow
OVERALL SEQUENCEÂ
DETAILED FLOWÂ
- INTERVIEW THE CUSTOMER FOR THE SYMPTOMÂ
- Interview the customer for the symptom (the condition and the environment when the incident/malfunction occurs).
>>
GO TO 2.
- CHECK SYMPTOMÂ
- Check the symptom from the customer information.
>>
GO TO 3.
- CHECK WARNING LAMP OPERATIONÂ
- Check air bag warning lamp operation in the user mode.
Are any malfunction detected?
YES>>
GO TO 5.
NO>>
GO TO 4.
- CHECK LOW VOLTAGEÂ
CONSULT Check low voltage.
Are any malfunction detected?
YES>>
GO TO 9.
NO>>
Check intermittent incident. Refer to Intermittent Incident .
- CHECK SELF DIAGNOSTIC RESULTSÂ
CONSULT Check "Self Diagnostic Result" or diagnosis mode.If it is impossible to switch to diagnosis mode, follow the same procedure that DTC is not detected.
NOTE:Perform the following procedure if DTC is detected:
- Record DTC. (Print them out.)
- Erase "Self Diagnostic Result".
- Study the relationship between the malfunction that DTC or air bag warning lamp indicates and the symptom that the customer describes.
- Check related service bulletins for information.
Is DTC detected?
YES>>
GO TO 6.
NO>>
GO TO 7.
- PERFORM DTC CONFIRMATION PROCEDUREÂ
- Perform DTC CONFIRMATION PROCEDURE for the DTC.
>>
GO TO 8.
- PERFORM DIAGNOSIS ACCORDING TO WARNING LAMP OPERATIONÂ
-
- Check air bag warning lamp operation in the user mode.
- Perform Diagnosis Procedure for the air bag warning lamp operation.
>>
GO TO 9.
-
- DETECT MALFUNCTIONING PART BY DIAGNOSTIC PROCEDUREÂ
- Inspect according to Diagnostic Procedure of the DTC.
>>
GO TO 9.
- REPAIR OR REPLACE THE MALFUNCTION PARTÂ
- Repair or replace the malfunctioning part.
>>
GO TO 10.
- ON BOARD DIAGNOSIS FUNCTIONÂ
- Check "Self Diagnostic Result" and air bag warning lamp operation in the user mode.
Is the malfunction repaired?
YES>>
Inspection End.
NO>>
GO TO 2.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
