2024 Infiniti QX50 AutographFACTORY OEM SERVICE PROCEDURE

System Description

SYSTEM DIAGRAM 

SYSTEM DESCRIPTION 

  • The adopted system enables comprehensive engine control. ECM (engine control module) performs various controls such as fuel injection control, ignition timing control, idling engine speed control, EVAP purge control and etc., and this system communicates with control unit such as CVT, ABS, etc. via CAN communication line.
  • The adopted diagnostic system corresponding to OBD (on board diagnostic) system enables various function check and easily malfunction diagnosis in the engine control system.
Function Reference
Fuel injection control System Description 
Fuel pressure control System Description 
Electric ignition control System Description 
Idling control System Description 
Cooling fan control System Description 
Intake valve timing control System Description 
Exhaust valve timing control System Description 
Intake manifold runner control valve control System Description 
Engine protection control (Low engine oil pressure) System Description 
Air conditioning cut control System Description 
Engine/CVT/ABS total control System Description 
Evaporative emission system System Description 
Fuel filler cap warning system System Description 
Power generation voltage variable control System Description 
VCR (variable compression ratio) system System Description 
Warning/Indicator/Chime
Fail-safe function Fail-safe 
On board diagnostic (OBD) system Diagnosis Description 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.