Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electric Throttle Control Actuator
FUNCTIONS WITHIN THE SYSTEMÂ
The ECM transmits the control signal to the electronically controlled throttle and controls the throttle position according to the driving conditions.
INDIVIDUAL FUNCTION WITHIN THE SYSTEMÂ
The electric throttle control actuator consists of throttle body, throttle valve, throttle control motor and throttle position sensor.
INDIVIDUAL OPERATIONÂ
Throttle Motor RelayÂ
Power supply for the throttle control motor is provided to the ECM via throttle control motor relay. The throttle control motor relay is ON/OFF controlled by the ECM. When the ignition switch is turned ON, the ECM sends an ON signal to throttle control motor relay and battery voltage is provided to the ECM. When the ignition switch is turned OFF, the ECM sends an OFF signal to throttle control motor relay and battery voltage is not provided to the ECM.
Throttle MotorÂ
The throttle control motor is operated by the ECM and it opens and closes the throttle valve.
Throttle Position SensorÂ
The throttle position sensor has two sensors. These sensors are a kind of potentiometers which transform the throttle valve position into output voltage, and emit the voltage signal to the ECM. In addition, these sensors detect the opening and closing speed of the throttle valve and feed the voltage signals to the ECM. The ECM judges the current opening angle of the throttle valve from these signals.
COMPONENT LOCATIONÂ
The electric throttle valve actuator is installed beside the intake manifold collector.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
