Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Re/Programming, Configuration
Configuration includes the following functions.
|
Item |
Description |
|
|
Read/Write Configuration |
Before replacing ECU |
Allows the reading of vehicle specification (Type ID) written in steering force control module to store the specification in CONSULT. |
|
After replacing ECU |
Allows the writing of vehicle information (Type ID) stored in CONSULT into the steering force control module. |
|
|
Manual Configuration |
Allows the writing of vehicle specification (Type ID) into the steering force control module by hand. |
|
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.