Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 Infiniti QX55 EssentialFACTORY OEM SERVICE PROCEDURE
Removal and Installation: Removal
- Disconnect negative battery terminal. Refer to Battery Disconnect .
- Remove passenger side fender protector. Refer to Removal and Installation .
- Disconnect steering angle sub control module connectors. Refer to Exploded View .
- Remove the bolts of steering angle sub control module. Refer to Exploded View .
- Remove the steering angle sub control module.CAUTION: When replacing control module, replace the following control modules as a set:
- Steering force control module
- Steering angle main control module
- Steering angle sub control module
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.