Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Work Procedure
- START
- Turn ignition switch ON.
- Check information display of the combination meter.
Is Distance to Engine Oil Change displayed?
YES
GO TO 3.
NO
GO TO 2.
- SELECT OIL CONTROL SYSTEM MODE
Push the Display next switch and select oil control system mode.
GO TO 3.
- RESET ENGINE OIL DATA
- Press and hold the Display Next switch at least 1 second while Distance to Engine Oil Change is displayed.
- Stop pressing the Display Next switch, and a few seconds later, check that the value of Distance to Engine Oil Change is reset.
END
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.