2022 Infiniti QX55 EssentialFACTORY OEM SERVICE PROCEDURE

Input Signal And Output Signal

Major signal transmission between each unit via communication lines is shown in the following table.

Component

Signal description

ECM

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication:

  • Accelerator pedal position signal
  • Engine speed signal
  • Engine torque signal

Mainly receives the following signal from ABS actuator and electric unit (control unit) via CAN communication:

  • Engine torque request signal

TCM

Mainly transmits the following signal to ABS actuator and electric unit (control unit) via CAN communication:

  • Current gear position signal

Chassis control module

Mainly transmits the following signal to ABS actuator and electric unit (control unit) via CAN communication:

  • Intelligent Trace Control

Combination meter

Mainly receives the following signals from ABS actuator and electric unit (control unit) via CAN communication:

  • Brake fluid level switch signal
  • Parking brake switch signal

Mainly receives the following signals from ABS actuator and electric unit (control unit) via CAN communication:

  • VDC warning lamp signal
  • VDC OFF indicator lamp signal

Steering angle sensor

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication:

  • Steering angle sensor signal
  • Steering angle sensor malfunction signal
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.