2022 Infiniti QX55 EssentialFACTORY OEM SERVICE PROCEDURE

Input Signal And Outlet Signal

Major signal transmission between each unit via communication lines is shown in the following table.

Component parts

Signal description

Combination meter

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.

  • Parking brake switch signal
  • Brake fluid level switch signal

Mainly receives the following signals from ABS actuator and electric unit (control unit) via CAN communication.

  • ABS warning lamp signal
  • VDC OFF indicator lamp signal
  • VDC warning lamp signal
  • Brake warning lamp signal

ECM

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.

  • Accelerator pedal position signal
  • Engine speed signal
  • Engine status signal
  • ECM malfunction signal

IPDM E/R

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.

  • Push-button ignition switch ON signal

BCM

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.

  • Stop lamp switch signal
  • Brake pedal position switch signal
  • Cranking signal
  • Push-button ignition switch ON signal

Chassis control module

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.

  • Active trace control signal
  • Active ride control signal

TCM

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.

  • Accelerator pedal position signal

Steering angle sensor

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.

  • Steering angle sensor signal
  • Steering angle speed signal
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.