Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Infiniti QX50 AutographFACTORY OEM SERVICE PROCEDURE
User Registration/Edit
Registration
- The Intelligent Key used for the first time calls up all the settings for Guest.
- Once a driver performs user registration on the AV control unit screen, the settings at this point are saved as the registered user information and linked with the Intelligent Key currently in use.
- If the Intelligent Key is used during the next drive, the registered user settings are applied.
If User A is registered while key 1 is used, for example, the vehicle uses the settings of User A when entering the vehicle with Key 1 the next time.
- For the user information, the setting status when the key switch is turned OFF is saved.
Change
- To change the current user settings to new user settings, the user settings can be changed in the AV control unit.
- Once a user change operation is performed, the new user and the currently used Intelligent Key are linked.
NOTE:
When the user is changed, the AV control unit screen enters a hatching state and prohibits the operation for approximately 2 seconds to secure the necessary period of time to change the user in each unit.
Delete
- The registered user information can be deleted.
- The Intelligent Key linked with the deleted user settings will call up the setting of Guest from the next time.
- If the current user is deleted, the settings for Guest are called up.
- The deleted user settings are changed *
to the default settings.
Copy
- The previously registered user settings can be copied to the settings of another user.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
