Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Detailed Flow
- INTERVIEW THE CUSTOMER FOR THE SYMPTOMÂ
Interview the customer for the symptom (the condition and the environment when the incident/malfunction occurs).
GO TO 2.
- CHECK SYMPTOMÂ
Check the symptom from the customer information.
GO TO 3.
- CHECK WARNING LAMP OPERATIONÂ
Check air bag warning lamp operation in the user mode.
Are any malfunction detected?
YES
GO TO 5.
NO
GO TO 4.
- CHECK LOW VOLTAGEÂ
CONSULT
Check low voltage.
Are any malfunction detected?
YES
GO TO 9.
NO
Check intermittent incident. Refer to Intermittent Incident .
- CHECK SELF DIAGNOSTIC RESULTÂ
CONSULT
Check "Self Diagnostic Result" or diagnosis mode.
If it is impossible to switch to diagnosis mode, follow the same procedure that DTC is not detected.
NOTE: Perform the following procedure if DTC is detected:- Record DTC. (Print them out.)
- Erase "Self Diagnostic Result" .
- Study the relationship between the malfunction that DTC or air bag warning lamp indicates and the symptom that the customer describes.
- Check related service bulletins for information.
Is DTC detected?
YES
GO TO 6.
NO
GO TO 7.
- PERFORM DTC CONFIRMATION PROCEDUREÂ
Perform DTC CONFIRMATION PROCEDURE for the DTC.
GO TO 8.
- PERFORM DIAGNOSIS ACCORDING TO WARNING LAMP OPERATIONÂ
- Check air bag warning lamp operation in the user mode.
- Perform Diagnosis Procedure for the air bag warning lamp operation.
GO TO 9.
- DETECT MALFUNCTIONING PART BY DIAGNOSTIC PROCEDUREÂ
Inspect according to Diagnostic Procedure of the DTC.
GO TO 9.
- REPAIR OR REPLACE THE MALFUNCTION PARTÂ
Repair or replace the malfunctioning part.
GO TO 10.
- ON BOARD DIAGNOSIS FUNCTIONÂ
Check "Self Diagnostic Result" and air bag warning lamp operation in the user mode.
Is the malfunction repaired?
YES
Inspection End.
NO
GO TO 2.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
