2022 Infiniti QX50 AutographFACTORY OEM SERVICE PROCEDURE

Input Signal And Output Signal

Major signal transmission between each unit via communication lines is shown in the following table:

Component

Signal description

ECM

Mainly transmits the following signals to chassis control module via CAN communication:

  • Accelerator pedal position signal
  • Engine torque signal
  • Engine speed signal

ABS actuator and electric unit (control unit)

Mainly transmits the following signals to chassis control module via CAN communication:

  • Front LH wheel speed signal
  • Front RH wheel speed signal
  • Rear LH wheel speed signal
  • Rear RH wheel speed signal
  • ABS operation signal
  • TCS operation signal
  • VDC operation signal
  • Stop lamp switch signal
  • Vehicle speed signal (ABS)
  • Yaw rate signal
  • Side G signal
  • Decel G signal
  • VDC OFF switch signal
  • Brake fluid pressure signal
  • Steering angle sensor signal

Mainly receives the following signal from chassis control module via CAN communication:

  • Active trace control signal

Steering angle sensor

Mainly transmits the following signal to chassis control module via CAN communication:

  • Steering angle sensor signal

Chassis control module

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication:

  • Active trace control signal
  • Drive mode signal

Integral switch

Mainly transmits the following signal to ABS actuator and electric unit (control unit) via CAN communication line:

  • Active trace control operation signal

Combination meter

Mainly receives the following signals from chassis control module via CAN communication:

  • Chassis control malfunction signal
  • Active trace control display signal
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.