2021 Infiniti Q60 Luxe, AWDFACTORY OEM SERVICE PROCEDURE

Confirmation Procedure

  1. CHECK DTC PRIORITY 

    If DTC P0507 is displayed with other DTC, first perform the confirmation procedure (trouble diagnosis) for other DTC.

    Is applicable DTC detected?

    YES

    Perform diagnosis of applicable. Refer to DTC Index .

    NO

    GO TO 2.

  2. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    If the idle speed is out of the specified value, perform Idle Air Volume Learning (Refer to Work Procedure ), before conducting DTC Confirmation Procedure.

    TESTING CONDITION:

    • Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.
    • Always perform the test at a temperature above -10 deg.C(14 deg.F).

    GO TO 3.

  3. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start engine and warm it up to normal operating temperature.
    2. Turn ignition switch OFF and wait at least 10 seconds.
    3. Turn ignition switch ON.
    4. Turn ignition switch OFF and wait at least 10 seconds.
    5. Start engine and run it for at least 1 minute at idle speed.
    6. Check 1st trip DTC.

    Is DTC P0507 detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Inspection .

    NO

    Confirmation after repair: INSPECTION END

Chapter Navigation
Return to Chapter: DTC P0507: ISC System
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.