2021 Infiniti Q60 Luxe, AWDFACTORY OEM SERVICE PROCEDURE

Confirmation Procedure

  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    Do you have CONSULT?

    YES

    GO TO 2.

    NO

    GO TO 4.

  2. PERFORM DTC CONFIRMATION PROCEDURE-I 

    SYMBOL With CONSULT

    1. Turn ignition switch ON.
    2. On CONSULT screen, select "ENGINE">>"Data Monitor">>"EVAP DIAG READY".
    3. Start engine and wait at idle until "OFF" of "EVAP DIAG READY" changes to "ON".
      NOTE: It will take at most 2 hours until "OFF" of "EVAP DIAG READY" changes to "ON".
    4. Turn ignition switch OFF and wait at least 90 minutes.
      NOTE: Never turn ignition switch ON during 90 minutes.
    5. Turn ignition switch ON.
    6. On CONSULT screen, select "ENGINE">>"Data Monitor">>"EVAP LEAK DIAG".
    7. Check that "EVAP LEAK DIAG" indication.

    Which is displayed on CONSULT?

    CMPLT

    GO TO 3.

    YET

    Perform DTC CONFIRMATION PROCEDURE again. GO TO 1.

  3. PERFORM COMPONENT FUNCTION CHECK-II 

    Check 1st trip DTC.

    Is DTC P0456 detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Inspection .

    NO

    Confirmation after repair: INSPECTION END

  4. PERFORM DTC CONFIRMATION PROCEDURE 

    SYMBOL With GST

    1. Start engine and wait engine idle for at least 2 hours.
    2. Turn ignition switch OFF and wait at least 90 minutes.
      NOTE: Never turn ignition switch ON during 90 minutes.
    3. Turn ignition switch ON.
    4. Check 1st trip DTC.

    Is DTC P0456 detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Inspection .

    NO

    Confirmation after repair: INSPECTION END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.