2021 Infiniti Q60 Luxe, AWDFACTORY OEM SERVICE PROCEDURE

Confirmation Procedure

  1. CHECK DTC PRIORITY 

    If DTC P0116 is displayed with DTC P0117 or P0118, first perform the confirmation procedure (trouble diagnosis) for DTC P0117 or P0118.

    Is DTC P0117 or P0118 detected?

    YES

    Perform diagnosis of applicable.

    NO

    GO TO 2.

  2. INSPECTION START 

    Is it necessary to erase permanent DTC?

    YES

    GO TO 4.

    NO

    GO TO 3.

  3. PERFORM COMPONENT FUNCTION CHECK 
    NOTE: Use the component function check to check the overall function of the ECT sensor 1 circuit. During this check, a 1st trip DTC might not be confirmed.
    1. Turn ignition switch OFF.
    2. Disconnect ECT sensor 1 harness connector.
    3. Remove ECT sensor 1. Refer to MULTI-WAY CONTROL VALVE : Exploded View .
    4. Check resistance between ECT sensor 1 terminals by heating with hot water as shown in the figure.
      G08855388Courtesy of NISSAN NORTH AMERICA, INC.

      ECT sensor 1

      Condition

      Resistance

      Terminal

      1

      2

      Temperature [ deg.C (deg.F)]

      20 (68)

      2.10 - 2.90 kOhm

      50 (122)

      0.68 - 1.00 kOhm

      90 (194)

      0.236 - 0.260 kOhm

    Is the inspection result normal?

    YES

    To check malfunction symptom before repair: Refer to Inspection .

    YES

    Confirmation after repair: INSPECTION END

    NO

    Refer to DTC Diagnosis Procedure .

  4. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TEST CONDITION:

    • Before performing the following procedure, do not add fuel.
    • Before performing the following procedure, check that fuel level is between 1/4 and 4/4.
    • Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.

    GO TO 5.

  5. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Move the vehicle to a cool place.
      NOTE: Cool the vehicle in an environment of ambient air temperature between -10 deg.C (14 deg.F) and 35 deg.C (95 deg.F).
    2. Turn ignition switch OFF and leave the vehicle for 12 hours.
      CAUTION: Never turn ignition switch ON during this procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.