x:Applicable

Part name	Service performed		Service Information item	Reference
Part name	Replacement	Removal	Service Information item	Reference
ECM	x	--	Additional service when replacing ECM	Refer to Work Procedure .
Accelerator pedal position sensor	x	x ^*1	Accelerator pedal released position learning	Refer to Work Procedure .
Electric throttle control actuator	x	x ^{*1, 2}	Throttle valve closed position learning	Refer to Work Procedure .
Electric throttle control actuator	x	x ^{*1, 2}	Idle air volume learning	Refer to Work Procedure .
Electric intake valve timing control module	x	x ^*1	Electric intake valve timing control actuator reference position learning	Refer to Work Procedure .
Electric intake valve timing control actuator	x	x ^*1	Electric intake valve timing control actuator reference position learning	Refer to Work Procedure .
Crankshaft position sensor	x	--	Electric intake valve timing control actuator reference position learning	Refer to Work Procedure .
Intake camshaft position sensor	x	--	Electric intake valve timing control actuator reference position learning	Refer to Work Procedure .
Exhaust camshaft position sensor	x	--	Electric intake valve timing control actuator reference position learning	Refer to Work Procedure .
engine mechanical parts timing chain intake/exhaust camshaft intake/exhaust camshaft sprocket Piston Connecting rod Crankshaft	x	x	Electric intake valve timing control actuator reference position learning	Refer to Work Procedure .
Turbocharger	x	--	Turbocharger wastegate control actuator initialization	Refer to Work Procedure .
A/F sensor 1	x	--	Idle air volume learning	Refer to Work Procedure .
O2 sensor 2	x	--	Idle air volume learning	Refer to Work Procedure .
Mass air flow sensor	x	--	Idle air volume learning	Refer to Work Procedure .
Repair or replacement of parts affecting air-fuel ratio	x	--	Idle air volume learning	Refer to Work Procedure .
Engine oil	x	--	Engine oil data reset	Refer to Work Procedure .

*1:Harness connector disconnection is included.

*2:Carbon deposit cleaning is included.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Service After Replacing Or Removing Engine Parts: Description

Use the Manual With the Right Hardware

When to See a Mechanic