2021 Infiniti Q50 Luxe, AWDFACTORY OEM SERVICE PROCEDURE

VR30DDTT engine

  1. INSPECTION START 

    Turn ignition switch OFF, and restart engine.

    Does the engine start?

    YES

    With CONSULT: GO TO 2.

    YES

    Without CONSULT: GO TO 3.

    NO

    Refer to Diagnosis Procedure .

  2. CHECK IGNITION SIGNAL FUNCTION 

    SYMBOL With CONSULT

    1. Perform "POWER BALANCE" in "ACTIVE TEST" mode with CONSULT.
    2. Make sure that each circuit produces a momentary engine speed drop.

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Refer to Diagnosis Procedure .

  3. CHECK IGNITION SIGNAL FUNCTION 

    SYMBOL Without CONSULT

    1. Let engine idle.
    2. Read the voltage signal between ECM harness connector terminals under the following conditions with an oscilloscope.

      ECM

      Voltage signal

      +

      -

      Connector

      Terminal

      Connector

      Terminal

      F142

      153

      E152

      204

      G08435929Courtesy of NISSAN NORTH AMERICA, INC.

      154

      161

      162

      164

      168

      NOTE: The pulse cycle changes depending on RPM at idle.

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Refer to Diagnosis Procedure .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.