2021 Infiniti Q50 Luxe, AWDFACTORY OEM SERVICE PROCEDURE

VR30DDTT engine

  1. CHECK FUEL PUMP CONTROL MODULE 
    1. Check the voltage between Fuel pump control module terminals under the following conditions.

      FUEL PUMP CONTROL MODULE

      Condition

      Voltage

      Connector

      +

      -

      Terminal

      Terminal

      B11

      1

      2

      For 1 second after turning ignition switch ON

      Approx. 9.9 V

      More than 1 second after turning ignition switch ON

      Approx. 0 V

      Idle speed

      Approx. 9.9 V

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Replace Fuel pump control module. Refer to FUEL PUMP CONTROL MODULE (FPCM) : Removal & Installation .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.