Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Vehicle Compartment
|
|
Around the battery |
|
Around the radiator |
|
Fuse and fusible link block |
|
|
Left side of trunk room |
|
Right side of main muffler |
|
Rear seat (lower right) |
|
No. |
Component |
Function |
|
|
Refrigerant pressure sensor |
Refer to Component Description . |
|
|
Battery current sensor (with battery temperature sensor) |
Refer to Component Description . |
|
|
IPDM E/R |
IPDM E/R controls the internal relays and the actuators. When CAN communication with ECM is impossible, IPDM E/R performs fail-safe control.
|
|
|
Electric intake valve timing control module |
Refer to Component Description . |
|
|
Cooling fan relay 2* |
Refer to Component Description . |
|
|
Cooling fan control module 2* |
Refer to Component Description . |
|
|
Cooling fan control module 1 |
Refer to Component Description . |
|
|
Cooling fan motor-1 |
Refer to Component Description . |
|
|
Cooling fan motor-2 |
Refer to Component Description . |
|
|
Cooling fan relay 1 |
Refer to Component Description . |
|
|
Fuel pump control module |
Refer to Component Description . |
|
|
EVAP canister vent control valve |
Refer to Component Description . |
|
|
EVAP control system pressure sensor |
Refer to Component Description . |
|
|
EVAP canister |
EVAP canister stores the generated fuel vapors in the sealed fuel tank to activated charcoals of EVAP canister when the engine is not operating or when refueling to the fuel tank. |
|
|
Fuel level sensor |
Refer to Component Description . |
|
|
Low pressure fuel pump |
Refer to Component Description . |
|
|
Fuel tank temperature sensor |
Refer to Component Description . |
*: For turbo high pressure model
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
