2021 Infiniti Q50 Luxe, AWDFACTORY OEM SERVICE PROCEDURE

System Description: Notes

  • The adoption of log-in function allows stored user-to-user settings to be called up through the recognition of the last user by the Intelligent Key.
  • The log-in function identifies the driver through the use of the Intelligent Key and calls up driver-specific settings for items such as audio, navigation, seat position, and PERSONAL mode settings of the Infiniti Drive Mode Selector.
  • For details of PERSONAL mode settings, Refer to System DescriptionΒ .
  • BCM receives a key ID signal from the Intelligent Key and transmits the signal to chassis control module, AV control unit, combination meter, A/C auto amp, driver seat control unit, and ADAS control unit via CAN communication.
  • Chassis control module transmits a key link signal to each unit via CAN communication.
  • AV control unit transmits a user information signal to each unit via CAN communication and AV communication.
  • Each unit calls up user information according to signals from BCM, chassis control module, and AV control unit.
    • BCM saves/reads set values of vehicle settings.
    • Driver seat control unit saves/reads set values such of seat position and mirror position.
    • A/C auto amp. saves/reads set values of temperature and DUAL settings.
    • Combination meter saves/reads set values of illumination control and language settings.
    • ADAS control unit saves/reads set values of warning sound and ON/OFF settings for each assist function.
    • Chassis control unit saves/reads settings of PERSONAL MODE characteristics of the Infiniti Drive Mode Selector.
    • Audio unit saves/reads set values of FM preset and balance.
  • The number of registrable Intelligent Keys interlocked with user settings is 4.
  • The driver's intelligent keys can be identified in the following order: Used for opening/closing by remote control -> located close to the driver's door -> identified at an engine start.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.