Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Inspection
- CHECK DRIVE MODE SELECT SWITCH
- Turn ignition switch OFF.
- Disconnect drive mode select switch harness connector.
- Check the continuity between drive mode select switch terminals as follows.
Drive mode select switch
Condition
Continuity
+
-
Terminals
1
2
Switch to down-position.
Existed
Other than the above.
Not existed
3
Switch to up-position.
Existed
Other than the above.
Not existed
Is the inspection result normal?
YES
INSPECTION END
NO
Replace drive mode select switch. Refer to DRIVE MODE SELECT SWITCH : Removal & Installation .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
