2020 Infiniti QX80 LimitedFACTORY OEM SERVICE PROCEDURE

DTC Detection Logic

DTC No.

Trouble diagnosis name

(Trouble diagnosis content)

DTC detecting condition

Possible Cause

P26A6

ENGINE COOLANT B/V A POSI SEN

(Engine coolant bypass valve A position sensor circuit low)

ECM detects the following status continuously for 5 seconds or more:

A voltage signal transmitted from the multi-way control valve position sensor is 0.34 V or less.

  • Harness or connectors

    (Multi-way control valve position sensor circuit is open or shorted.)

  • Multi-way control valve position sensor
  • Sensor power supply 2

P26A7

ENGINE COOLANT B/V A POSI SEN

(Engine coolant bypass valve A position sensor circuit high)

ECM detects the following status continuously for 5 seconds or more:

A voltage signal transmitted from the multi-way control valve position sensor is 4.76 V or more.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.